Tripp-Lite SRCOOLNET Instalación Y Guía De Inicio Rápido página 8

Installation
DO NOT MODIFY UNLESS DIRECTED BY YOUR ADMINISTRATOR
Do you want to completely erase the file system? [N]
DO NOT MODIFY UNLESS DIRECTED BY TRIPP LITE TECHNICAL SUPPORT
Default Ethernet setting (0=Auto, 1=10 Half, 2=10 Full, 3=100 Half, 4=100
Full)? [Auto]
DO NOT MODIFY UNLESS DIRECTED BY YOUR ADMINISTRATOR
You can also change the root password, real-time clock and other settings.
Tripp Lite recommends against changing the default settings unless you are an
advanced user with a specific purpose. After you have finished entering settings,
the SRCOOLNET will save changes to memory and reboot (this may take several
minutes). After the SRCOOLNET reboots, the initialization page should display the
new static IP settings.
3-8
Remove Configuration Cable: Remove the configuration cable that connects
the SRCOOLNET to the computer.
4 - Test and Configure
4-1
Test Network Connection: After an IP address has been assigned to the
SRCOOLNET, try to access it with a Web browser that supports frames, forms
and Java™. Open a Web browser on a computer connected to the LAN and enter
the SRCOOLNET's IP address. You will be prompted for a password. The user
name is localadmin and the default password is localadmin. After you enter the
user name and password, the PowerAlert Status page will appear in the browser
window. For more information about configuration and operation of the managed
device, refer to the User's Guide, included on the CD-ROM bundled with the
SRCOOLNET.
Note: When using the SRCOOLNET with the SRCOOL12K or SRXCOOL12K, do
not use the cooling unit's manual control panel.
13-08-187 93-32CA.indb 8
8
9/27/2013 9:25:21 AM