Customer Responsibilities; To Check Safety Valve - Porter Cable C2002 Manual De Instrucciones

NOTE: The hose or accessory will require a quick connect plug if the air outlet is
equipped with a quick connect socket.
sure rating for air tools and accessories. The regulator outlet pressure must
never exceed the maximum pressure rating.
air at an item that could be damaged by moisture. Some air tools and accessories
may require filtered air. Read the in struc tions for the air tools and accessories.
How to Start
1. Set the On/Off switch to "On" and allow tank pressure to build. Motor will stop
when tank pressure reaches "cut-out" pressure.
2. Turn regulator knob clockwise to increase pressure and stop when desired
pressure is reached.
checked by a trained service technician.
The compressor is ready for use.

CUSTOMER RESPONSIBILITIES

Check Safety Valve
Drain Tank
compressed air, or moving parts. Personal injuries can occur. Before perform-
ing any maintenance or repair, disconnect power source from the compressor
and bleed off all air pressure.
NOTE: See Operation section for the location of controls.

TO CHECk SAFETY VALVE

an explosion.
side shields.
1. Before starting compressor, pull the ring on the safety valve to make sure
that the safety valve operates freely. If the valve is stuck or does not operate
smoothly, it must be replaced with the same type of valve.
NOTE: See Operation section for the location of controls.
N003568
Risk of Bursting. Too much air pressure causes a hazardous
risk of bursting. Check the manufacturer's maximum pres-
Risk of unsafe operation. Compressed air from the unit may
contain wa ter condensation and oil mist. Do not spray un fil tered
Risk of unsafe operation. If any unusual noise or vibration
is noticed, stop the compressor immediately and have it
MAINTENANCE
Before
each use
x
Unit cycles automatically when power is on. When perform-
ing maintenance, you may be exposed to voltage sources,
Risk of Bursting. If the safety valve does not work properly,
over-pressurization may occur, causing air tank rupture or
Risk from Flying Objects. Always wear certified safety
equipment: ANSI Z87.1 eye protection (CAN/CSA Z94.3) with
Daily
or after
each
use
x
12 - ENG