Auriol Z31915 Instrucciones De Utilización Y De Seguridad página 54

Connecting the weather station with the outdoor sensor and the
DCF radio signal:
After removal of the battery safety strip the weather station attempts to establish a
connection with the outdoor sensor. This process can take a few minutes. The symbol
will keep flashing for few minutes. On successful connection with the outdoor sensor,
the selected channel symbol
outdoor sensor (if necessary you can change the channel of the outdoor sensor as
shown in the section "Setting the channel"). If the connection with the outdoor sen-
sor is not established automatically, this can be done manually as follows:
1. Press the channel button (CH)
flash in the LC-display. Outdoor temperature
display "--._", weather station will start receive the outdoor sensor signal process.
2. Then press the RESET button
temperature
25
As soon as the weather station has established a connection with the outdoor sensor
it automatically begins to receive the DCF radio signal. This process takes several
minutes and is indicated in the LC display by a flashing radio tower symbol
When the DCF radio signal is being successfully received, the radio tower symbol
is shown permanently in the display. If at the time of putting the device into opera-
tion it is not possible to synchronise with the atomic clock, you can also carry out
54 GB/IE
appears in the LC display with the channel of the
27
. The icon of the selected channel
37
of the sensor. Weather station outdoor
43
and Humility(Outdoor)
and Humility(Outdoor)
25
will display exiting value.
22
will
27
will
22
.
5