Air Pressure Measuring Units (Inhg/Hpa); Relative Pressure Setting; Forecast Sensitivity Setting; Features And Operation - La Crosse Technology WS-7394U Manual De Uso

2. "lcd" will appear at the top of the display and a number will flash
next to it.
3. Press and release the "SET" button ten more times to advance to
the Temperature Measuring Units setting.
4. ˚F or ˚C will flash at the top of the display.
5. Press and release the "OUT/+" button to select the desired tem-
perature-measuring unit.
6. Press and release the "SET" button to confirm the temperature-
measuring unit and continue to the Air Pressure Measuring Units
setting.
M. Air Pressure Measuring Units Selection (inHg/hPa)
1. Press and hold the "SET" button for five seconds.
2. "lcd" will appear at the top of the display and a number will flash
next to it.
3. Press and release the "SET" button eleven more times to advance
to the Air Pressure Measuring Units setting.
4. inHg or hPa will flash at the top of the display.
5. Press and release the "OUT/+" button to select the desired air pres-
sure-measuring unit.
6. Press and release the "SET" button to confirm the air pressure-
measuring unit and continue to the Relative Pressure setting.
N. Relative Pressure Setting
1. Press and hold the "SET" button for five seconds.
2. "lcd" will appear at the top of the display and a number will flash
next to it.
GB
P.13
3. Press and release the "SET" button twelve more times to advance
to the Relative Pressure setting.
4. The barometric air pressure will flash in the middle of the display,
just below the forecast icon
5. Press and release the "OUT/+" or "IN" button to select the desired
air pressure-measuring unit.
6. Press and release the "SET" button to confirm the relative pressure
setting and continue to the Forecast Sensitivity setting.
O. Forecast Sensitivity Setting
1. Press and hold the "SET" button for five seconds.
2. "lcd" will appear at the top of the display and a number will flash
next to it.
3. Press and release the "SET" button thirteen more times to advance
to the Forecast sensitivity setting.
4. The two air pressure tendency arrows will begin flashing on either
side of the forecast icon and a flashing number will appear under
the forecast icon.
5. Press and release the "OUT/+" button to select the desired forecast
sensitivity setting.
Note: Barometric air pressure is usually reported as "relative air
pressure". This reading is based on the combination of absolute air
pressure and altitude. In general, an increase in altitude will result in a
decrease in air pressure. Relative air pressure will make readings in
nearby locations relative to each other to allow for proper forecasting.
The absolute air pressure reading in the Weather Center cannot be
calibrated, only the relative air pressure.
6. Press and release the "SET" button to confirm the forecast sensi-
tivity setting.
THE MANUAL SETTING IS NOW COMPLETED
FEATURES AND OPERATIONS
A. Minimum and Maximum Temperature and Humidity
1. Indoor Minimum and Maximum Temperature and Humidity
The indoor weather station automatically stores the minimum and
maximum indoor temperature and humidity. The minimum and maxi-
mum values are updated automatically when a new minimum or maxi-
mum is recorded, or until manually reset.
a. From the normal display mode, press and release the "IN" key
once to view the indoor maximum temperature and humidity
GB
P.14