EWT CS 2 Instrucciones De Uso página 38

BEFORE YOU START
WARNING!
You must first read and understand the section on
"precautions and guidelines regarding safety" and take them
into account.
Guidelines: Never vacuum dangerous substances.
1. Make sure the appliance is not plugged into the mains. Check that the container is clean and dust
free. (Fig. 1)
2. Remove the dust bag and the reusable cloth filter. Leave only the foam filter on the filter housing.
Replace the upper part of the container and close the container clasps. (Fig. 2)
DO NOT USE a dust filter for vacuuming liquids
OPERATION: VACUUMING LIQUIDS
1. Insert the largest end of the hosepipe into the suction port on the front of the container and lock it by
turning it to the right. Select the desired nozzle or the extension(s) and fit them onto the hosepipe. (Fig. 3)
2. Make sure the Stop/Start switch on the appliance is in the "Stop" position ("O" position) before plugging
into the mains. (Fig. 4)
3. Start the motor (Start/Stop switch in the "Start" position ("I" position). (Fig. 5)
When you have finished vacuuming, stop the motor by putting the Start/Stop switch in the "Stop"
position ("O" position). Unplug from the mains.
4. After use, empty the container and dry it.
IMPORTANT! If you wish to vacuum large quantities of liquid from
a sink, a tank or similar, do not place the whole of the nozzle in the
liquid, but leave a little room so that are can be vacuumed along
with the liquid. The appliance is fitted with a float switch which
blocks vacuuming when the container is full. You can tell when vac-
uuming stops because the motor turns faster. If this happens, stop
the appliance immediately and disconnect from the mains. Take
into account that a full container can be very heavy. Remove the
upper part of the container and pour the liquid into a suitable recipi-
ent or into a runoff. You can then continue vacuuming once you
have reinstalled the upper part. After vacuuming liquids, stop the
appliance and disconnect from the mains. Empty the container and
clean and dry it on the inside and the outside before storing it.
Reminder!
vacuuming liquids and a dust filter installed before starting to
vacuum dry waste.
The foam filter should
38
be removed after