Blowing Operation; Maintenance - EWT CS 2 Instrucciones De Uso

1
1. Push the large end of the flexible hose into the blower connection in the top of the motor housing
(Fig. 1).
2. Ensure the power switch is turned off and plug into the power supply (Fig. 2).
3. Switch on the power (Fig. 3).
4. The unit will now blow through the vacuum hose, and can be used to clear obstructions within the pipe
(Fig. 4).
WARNING! If the hose is still blocked after a few seconds, turn
off the unit and clear the hose manually.
1
6
1. Verify that the power cable is disconnected from the outlet (Fig. 1).
2. Disconnect the hose from the container (Fig. 2)
3. Undo the clasps and remove the top section from the container (Fig. 3).

BLOWING OPERATION

2

MAINTENANCE

2 3
3
4
39
4
5