Sweep Modes; Specification - TTI TG210 Manual Del Usuario

FREQUENCY
Frequency Range:
Vernier Range:
Vernier Accuracy:

SWEEP MODES

INTERNAL (TG230 only)
Sweep Range:
Sweep Rate:
Sweep Mode:
EXTERNAL
Input Impedance:
Input Sensitivity:
Maximum Allowable
Input Voltage:
Sweep Linearity:
Maximum Slew Rate
of sweep voltage:
AMPLITUDE MODULATION (TG230 only)
Depth:
Frequency:
External Sensitivity:
METER ACCURACY (TG215/TG230 only)
Frequency:
Amplitude:
DC Offset:
Resolution:
2
.02Hz to 2MHz in 7 overlapping decade ranges with fine adjustment by a
vernier.
1000:1 on each range, except 2Hz and 20Hz range (>100:1).
Typically ±5% of full scale for TG210; see Meter Accuracy for TG215 and
TG230.
1000:1 within each range, except 2Hz and 20Hz range (>100:1).
Adjustable, typically 20ms to 20 secs.
Linear or logarithmic. Sweep start and stop frequencies displayed at the
press of a button.
10kΩ
0 to 3V for 1000:1 sweep.
±10V
Better than 1%
0.1V/us
Variable 0 to 100%
400Hz (internal). DC to 100kHz (external).
Approximately 2V peak-to-peak for 100% modulation.
±1 digit on all ranges; reducing to 1% of full scale at:
<2·30Hz on 20Hz range (SYM off)
<·230Hz on 2Hz range (SYM off)
and <2·30Hz on 200Hz range (SYM on)
<·230Hz on 20Hz and 2Hz ranges (SYM on)
Typically 5% of range; display corrected for attenuator setting.
Typically 2%; display corrected for attenuator setting.
Frequency:
Amplitude and DC Offset: 0·5% of range full scale

Specification

0·05% of range full scale.