Publicidad
Idiomas disponibles
Idiomas disponibles
b
lade
install handle
NOTE
The Barrier Bar is required when using grass or weed blades. Units
equipped with U-Handles do not require installation of the Barrier
Bar.
SRM's with 4-screw front handles
1.
Position front handle on shaft and install Barrier Bar using four (4)
5x35 mm screws and (4) new nuts included with kit. Handle must
be at least 10 inches (250 mm) from center of rear handle grip.
2.
Adjust handle position for comfortable operation, and tighten
screws securely.
SRM's with 2-screw front handles
1.
Position front handle on shaft and install Barrier Bar using two
(2) 5x35 mm screws provided in kit. Handle must be at least 10
inches (250 mm) from center of rear handle grip.
2.
Adjust handle position for comfortable operation, and tighten
screws securely.
NOTE
The Barrier Bar is not a handle.
install shield and gear housing assembly
1.
Install gearbox assembly on end of drive shaft taking care to
engage the drive cable with the gear housing.
2.
Aling the gear housing on the drive shaft and install the locating
screw (N).
3.
Tighten the two (2) side clamping screws (M).
IMPORTANT
Flat edge of washers (O) must be against drive shaft.
c
onversion
/
barrier bar
k
i
it
nstallation
i
nstructions
O
N
O
5
M
M
Publicidad
