oneConcept 10029373 Manual Del Usuario página 48

Back light Mode
IF the LED is off, press the LIGHT button once. The backlight will turn on for five seconds,
and if no operation is performed for three seconds, the backlight will turn off.
Press and hold the LIGHT key for two seconds, and the backlight will turn on permanently,
and display LED ON icon will be displayed for three seconds in the time field. IF the LED is
on, press and hold the LIGHT button once, and the LED will turn off.
To dim the backlight display, press the SNOOZE/LIGHT button (on the top of the console)
to toggle the backlight contrast level between 1 (the lowest setting) and the current setting
(1-8).
To easily adjust the backlight when the backlight is on, press the SNOOZE/LIGHT button
twice in quick succession to enter the Backlight Contrast Mode. BRIGHT 4 will be displayed.
Press [+] key or [-] key to adjust contrast value from 1 to 8, and press the SET key to exit.
NOTE: If plugged into AC power, the time area will display AC ON and the backlight will
remain on. It is not recommended leaving the backlight on for a long period of time when
operating on batteries only, or the batteries will run down quickly.
Adjustment or Calibration
NOTE: The calibrated value can only be adjusted on the console. The remote sensor(s)
always displays the un-calibrated or measured value. The measured humidity range is bet-
ween 10 and 99%. Humidity cannot be accurately measured outside of this range. Thus,
the humidity cannot be calibrated below 10% or above 99%.
The purpose of calibration is to fine tune or correct for any sensor error associated with the
devices margin of error. The measurement can be adjusted from the console to calibrate to
a known source.
Calibration is only useful if you have a known calibrated source you can compare it against,
and is optional. This section discusses practices, procedures and sources for sensor cali-
bration to reduce manufacturing and degradation errors. Do not compare your readings
obtained from sources such as the internet, radio, television or newspapers. They are in a
different location and typically update once per hour.
The purpose of your weather station is to measure conditions of your surroundings, which
vary significantly from location to location. The unit supports up to eight remote sensors.
Each of the eight sensors can be calibrated.
If you own more than one remote sensor, press the CHANNEL/+ button first to display the
specific channel you wish to calibrate.
48