Cleaning The In-Line Filter; Sweep Hose - Hayward VIPER 5500 Guia Del Usuario

Maintenance
R e m oving the Viper Cleaner From The Po o l
Warning – Risk of Injury
The Filtration Pump and Booster Pump must be O F F w h e n
connecting or disconnecting cleaner or hose.
1 . Turn the Booster Pump and Filtration Pump OFF.
If you will not be replacing the cleaner before the next
Booster Pump timer cycle, turn the Booster Pump Ti m e r
O F F. Never run the Booster Pump without the cleaner
c o n n e c t e d . Failure to do so can cause serious injury.
Risk of Equipment Damage. N e v e r run the Booster
Pump without the Cleaner connected. Doing so will damag e
the pump's motor and void the Booster Pump's warranty.
2 . From the pool deck looking down push the Wall Quick
Connect into the Universal Wall Fitting and turn it to the right
( c l o c k w i s e ) .
3 . Pull the Wall Quick Connect out of the Universal
Wall Fitting.
4 . Remove the cleaner from the pool.
5 . Disconnect the Cleaner Connector from the Viper cleaner.
6 . L ay the Pressure Hose and Sweep Hose fl at and straight.
I m p o r t a n t : A lw ays store the Pressure Hose and Sweep
Hose straight, not coiled. The cleaner may not operat e
p r o p e r ly with bent hoses.
Emptying the Debris Bag
Empty the Debris Bag regularly. Do not continue to operate the
Viper when the bag is full.
Sand (dense debris): Always empty the Viper bag when
sand (or heavy debris) fills the bag up to the blue " E m p t y
Sand Line".
D O N OT operate the Viper if it runs on its side.
1 . Hold Bag over trash can or wherever debris is to
be placed.
2 . Slide Float Closure off of bag
3 . Hold open edges apart and shake debris from bag .
4 . Slide Float Closure onto bag .
14

Cleaning the In-Line Filter

1 . The In-Line filter (Part S) is located by the Wall Quick
Connect (Part L).
2 . To remove the screen inside the In-Line Filter, unscrew
the cap of the In-Line Filter and remove the screen.
3 . Remove the debris from the screen and rinse. I m p o r t a n t : I f
the screen frequently becomes plugg e d , the filtrat i o n
system is not performing properly or there is another
plumbing problem.
4 . Place the open end of the screen into the outlet end of the
In-Line Filter and screw the cap back on. I m p o r t a n t : M a k e
sure the O-Ring is in place and properly seat e d .
In-Line Filter
In-Line Filter
Screen
Caution – Risk of Equipment Damage
Never operate the cleaner without the screen in place.
O p e r ating the cleaner without the screen will damage the
c l e a n e r 's internal mechanism.

Sweep Hose

• Sweep Hose Wear Rollers will experience wear when
o p e r ating in a plastered or concrete pool.
• When the Wear Rollers wear-down to the outer groove (We a r
Line) replace the Wear Rollers (P/N A X 5 0 0 6 A ) .
• Check the Sweep Hose for holes.
Wear Roller
Use Only Genuine Hayward Replacement Parts.
Wear Line
(outer groove)