ergoCentric upCentric Manual Del Usuario página 11

Step 7 :
Run power cord (G) and
control button wire through frame
at desired locations.
7.1 :
Plug power cord into back
of control box.
7.2 :
Run power cord through
the inlet hold on side of frame.
7.3 :
Run control button
wire through the inlet hole on
opposite side of power cord
inlet hole. (plastic wire cover
clips into inlet hole).
Step 8 :
Attach table top and
control buttons.
8.1 :
Place the frame in the center
of the table top and attach frame
to table top with 14 screws.(D)
8.2 :
Attach control buttons to
the table top with screws (E) and
secure all loose wires into wire
clips on underside of frame.
Step 9 :
Reset control box before adjusting. Press and hold both up and
down buttons together for 3 to 5 seconds until you hear a beep.
7.1
7.2
8.1
7.3
8.2
11