Multi-Level Set-Up - Heidolph UNIMAX 2010 Instrucciones De Empleo

funnel and its closing plug by means of compression spring (3). Dimension "A" once set funnel and its closing plug by means of compression spring (3). Dimension "A" once set
will be good for one and the same size of separating funnel only. Whenever using a will be good for one and the same size of separating funnel only. Whenever using a
different model of separating funnel, you need to check dimension "A" and readjust different model of separating funnel, you need to check dimension "A" and readjust
accordingly. accordingly.
• •
Install washer (4) and nuts (5) on bolts of parts (1) and (2); pull tight with box-end spanner Install washer (4) and nuts (5) on bolts of parts (1) and (2); pull tight with box-end spanner
(6) from your hardware bag. (6) from your hardware bag.
Locate rack with holders on shaker plate. Locate rack with holders on shaker plate.
Make sure, crimped edge (10) is plugged over the shaker plate (11), so positively locking both Make sure, crimped edge (10) is plugged over the shaker plate (11), so positively locking both
parts with each other. parts with each other.
Install separating funnel: Install separating funnel:
Install separating funnel with its outlet pipe (7) first through compression spring (3); press item Install separating funnel with its outlet pipe (7) first through compression spring (3); press item
against compression spring (3) until closing plug (8) kocks with retainer ring (9). against compression spring (3) until closing plug (8) kocks with retainer ring (9).
Before starting shaking, make sure that the outlet pipes (7) of your separating
funnels are clear of other items on your lab bench. Maintain sufficient space
between separating funnels to avoid a collision situation.
3.4. Hardware for multi-level set-up
This hardware allows installation of a second or third rack plate for Erlenmeyer flasks on the
shaker plate.
Using 25 ml Erlenmeyer flasks, a total of 3 racks may be set-up the same time, whereas 50
ml to 250 ml Erlenmeyer flasks may be arranged on 2 only racks.
Components: installation hardware for multi-level set-up, P/N 549.60000.00;
extra racks with clamps for Erlenmeyer flasks, as described under para. 3.2.
Set-up:
D
C
B
1
Please pay attention to the position:
wingbolt (on clamping sleeve)
situated below
4
3
A
23 23
IEI
Pos 4: wingbolts must
be adjusted vertically to
the outer edge of the
platform