Warranty Terms - FuelTech Peak and Hold Manual De Instalación Y Operación

3. Warranty terms

The use of this equipment implies the total accordance with the
terms described in this manual and exempts the manufacturer
from any responsibility regarding to product misuse.
Read all the information in this manual before starting the product
installation.
This product must be installed and tuned by specialized auto
shops and/or personnel with experience on engine preparation
and tuning.
Before starting any electric installation, disconnect the battery.
The inobservance of any of the warnings or precautions described in
this manual might cause engine damage and lead to the invalidation of
this product warranty. The improper adjustment of the product might
cause engine damage.
This product does not have a certification for the use on aircrafts or
any flying devices, as it has not been designed for such use purpose.
In some countries where an annual inspection of vehicles is enforced,
no modification in the original fuel injection system is permitted.
Be informed about local laws and regulations prior to the product
installation.
Important warnings for the proper installation of this product:
- Always cut the unused parts of cables off – NEVER roll up
the excess as it becomes an interference capturing antenna and
it can result on equipment malfunction.
- The black wire in the cable MUST be connected directly to
the battery's negative terminal, as well as each one of the sensors'
ground wires.
- The black/white wire MUST be connected directly to the
engine block or head. By doing so, many interference problems
are avoided.
- To prevent possible damage to the module install the 4
mounts that come with the product.
Peak and Hold
EN
5