Control Panel Features - Wh1000I - Westinghouse WH1000i Manual Del Propietário

FEATURES
Control PanEl FEaturEs – wH1000i
1 - 120-Volt, 20-Amp Duplex Outlet (NEMA
5-20R): The outlet is capable of carrying a
maximum of 20 amps.
2 - Reset breaker: If the inverter is overloaded,
the reset breaker will trip. The engine will
continue to run, but there will be no output
from the inverter. Unplug the devices and
reduce the load. Push in the reset breaker to
reset it.
3 - Choke knob: Pull out to the ON position
to start the engine, and push in to the OFF
position once the engine is running.
4 - Efficiency Mode Switch: When turned to the
ON position, the engine will sense the load
needed and run at a slower RPM to save fuel.
18
1
8 7 6
Figure 8 – Control Panel Features
2
4
5
5 - Ground Terminal: The ground terminal is used
to externally ground the inverter.
6 - Low Oil LED: The red light will come on
and the engine will shut down if the oil level
becomes low. You must add oil to the correct
level before the inverter can be restarted.
7 - Overload LED: The red light will come on if the
inverter is overloaded. Decrease the load before
restoring inverter operations.
8 - Output Ready LED: The light will be green
when the inverter is ready to be used.
3