BaByliss PRO X2 VOLARE FX811 Manual Del Usuario página 4

• Before each use, apply oil at the places marked with
arrows (see page 12).
• Do not allow permanent wave lotion, hair restorer or hair spray
to come into contact with the main body or the blades. Doing
so may result in cracking, discoloring or corrosion.
• Do not drop the clipper on the floor.
• Do not knock the blades and the attachments against hard objects.
• Do not use the clipper to trim the hair of a pet.
CLIPPER CLEANING PRECAUTIONS
• Clean the housing using only a cloth slightly dampened with
water or a mild soap solution.
• Never use a caustic solution.
• Never submerge the clipper in water.
GENERAL CLIPPER PRECAUTIONS
• This appliance is not intended for use by persons (including
children) with reduced physical, sensory or mental capabilities,
or lack of experience and knowledge, unless they have been
given supervision or instruction concerning use of the appli‑
ance by a person responsible for their safety. Children should be
supervised to ensure that they do not play with the appliance.
• Never tamper with moving parts.
• Avoid grabbing the clipper by the power cord, as it may be‑
come detached, causing damage or injury.
• If the clipper is not working properly, have it inspected at an
authorized service center.
6
CHARGING THE CLIPPER
1 .
Slide the power switch to OFF position.
2.
Connect the plug from the AC adapter to the unit. Plug adapter
into wall outlet. The LED will turn red to indicate charging.
3.
Place the unit on the stand or on a counter.
• It will take approximately 3 hours for the clipper to fully charge, as
indicated by the blue LED light. This will give you approximately 3
hours or more of run time.
• Your clipper can be quick charged for approximately 1 hour,
providing about 75 minutes of run time. Note the LED light may
not change from red to blue.
• Important Note: To prolong the life of your battery, it is recom‑
mend that you wait for the flashing red LED before charging
your clipper.
ABOUT THE LED DISPLAY
.
Your clipper has one LED to indicate the different modes.
Red: the unit is charging.
Blue: the unit is fully charged.
Slow Flashing Red: early warning indicates the unit will soon
need to be charged.
Rapid Flashing Red: indicates only 10 to 15 minutes more
run time.
7