Honeywell RCA902N Instrucciones De Instalación página 12

Detector de movimiento inalámbrico
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Installation Instructions
Slowly walk across the detection area approximately 15 ft. from the unit. As you cross
a detection zone and your movement is detected a small red indicator behind the
lens will illuminate for a few seconds. Stand still until the indicator goes out after a
few seconds. Continue moving around at various distances and angles to the unit,
stopping each time the indicator illuminates, until you have established the detec-
tion area. If the detector has already been linked to the Switching Receiver or Chime
when the Walk test is performed then the lights will illuminate
for approximately 5 seconds or the Chime will sound each time
movement is detected.
Adjust the position of the detector head to obtain approxi-
mately the desired detection area as required. Angling the
detector head downwards will reduce the range and produce a
smaller coverage area. Angling the head upwards will increase
the range and produce a larger coverage area. If necessary the
M27298
Fig. 6
detection area can also be reduced by masking the detection
window (see page 13).
69-2157EFS—05
10
69-2157EFS_C.indd 10
9/22/2008 11:54:01 AM

Publicidad

Tabla de contenido
loading

Tabla de contenido