Publicidad
Idiomas disponibles
Idiomas disponibles
the user to apply paints, varnishes, primers,
preservatives,
protective
materials, as well as to spray water for wetting
surfaces.
Components
1 Nozzle
2 Air cap
3 Nut of air cap
4 On / off switch
5 Valve
6 Cap of reservoir
7 Reservoir
8 Regulator spraying width
9 Control the amount of the sprayed substance
10 Inlet connection
11 Regulator air flow
12 Brush *
13 Universal key *
14 Quick-change adapter *
15 Filter *
16 Locking lever *
17 Nut of reservoir *
18 Nut of reservoir (special) *
19 Nut
20 Tube
21 Lock ring
22 Needle
23 Spring
24 Gasket
25 Ring
* Optional extra
Not all of the accessories illustrated or
described are included as standard delivery.
Installation / regulation
Before execution of any procedures, discon-
nect air tool from compressor.
Reservoir (see fig. 1-5)
•
Detach / attach reservoir 7 as it is shown in
figures 1-2, 4-5.
•
Open / close cap 6 of a reservoir 7 as it is
shown in figures 1-2, 4-5.
•
For CT38103. Before working place the
tube 20 in the correct position (see fig. 3).
Quick-change adapter (see fig. 6.1)
Screw / unscrew quick-change adapter 14 to the
inlet connection 10 as shown in figure 6.1.
and
disinfectant
English
18
Initial operation
•
Before first using wash with solvent details of
air tool to away grease conservation.
•
Check before each using of the tightness of all
threaded connections, as well as the tightness of
connections and hoses.
Switching on / off
Air tool should be pre-connected to the
compressor.
Switching on:
Press and hold the on / off switch 4.
Switching off:
Release the on / off switch 4.
Design features
•
Adjust the amount of spray, using the regula-
tor 9, as shown in figure 6.2.
•
Adjust the air flow, using the regulator 11, as
shown in figure 7.1.
•
Adjust the width of the spray, using the regula-
tor 8, as shown in figure 7.2, 8.
•
Adjust the position of spray cone as shown in
figure 9.
Working advice
Work sequence (see fig. 6-10)
Dilute the spray material to the desired
•
viscosity, mix thoroughly and strain the resulting
composition.
•
Connect the air tool to the compressor, using
a special air hose with an internal diameter of at
least 8 mm. It is recommended to use a moisture /
oil separator.
•
Open cap 6, fill reservoir 7 with the sprayed
material, close cap 6.
With regulators 8, 9, 10 adjust the spraying
•
torch and the amount of the sprayed material
(see fig. 6-9).
•
Do a trial treatment on an unnecessary piece
of the same material in order to make sure that
the adjustments are correct.
•
Spray material from a distance of 15-30 cm
from the surface (see fig. 10.1).
•
Start spraying beyond the bounds of the
treated surface.
Move the spray gun moving your arm as
•
shown in figure 10.1, and not only the wrist (see
Publicidad
