Touch Control Panel - Thermador PH30HWS Manual Del Usuario

Touch Control Panel

NOTE: Not all features referred to in this manual applies to all models.
a
b
L H LAMP FILTER DELAY
(a) LH LAMP Left Heat Lamp (PHxxGWS only)
Independently controls the left infrared heating lamp, turning the lamp on or off.
(b) FILTER Clean Filter Reminder
After 40 hours of operation, the FILTER button will illuminate indicating that the filters need to be
cleaned. When this indicator illuminates clean the filters as instructed on page 14.
To receive a reminder notification to clean the filters through the Home Connect™ app, activate the
feature in the Settings section of the app. You may also review the status of the filter saturation within
the Home Connect app.
To turn OFF the Clean Filter Reminder:
After cleaning, press and hold the FILTER button for 3 seconds until it beeps to reset the 40-hour
period and to turn the reminder off.
(c) DELAY Delay Shut Off
If the blower is off when the DELAY button is pressed, the blower will turn on to the high speed
setting for 10 minutes. At the end of the 10 minutes the blower will automatically turn off. If the
blower is on when the DELAY button is pressed, the blower runs for 10 minutes from the time the
DELAY button was pressed at the current speed then turns off. During the 10 minute timed period,
the DELAY button is illuminated. To interrupt a timed period, press one of the fan speed buttons or 0
button to turn off.
An ability to choose a different time period other than the default setting is also possible through the
Home Connect™ app in the SETTINGS menu.
(d) 0 OFF
Touch '0' once to turn the blower off and reset the control.
(e) 1 – 4 Fan Speed
Increases or decreases the blower speeds. The chosen blower speed LED will remain illuminated
while in operation.
1 – Low
2 – Medium
3 – Medium/High
4 – High
You may also remotely control and monitor hood fan speeds through the Home Connect app. An
ability to choose a different speed other than the default setting is also possible through the Home
Connect app in the SETTINGS menu.
(f) AUTO Automatic Mode
When in AUTO mode, the hood automatically turns the blower on, depending on the amount of heat
the control senses. It automatically adjusts every 5 minutes. If the control does not sense a high level
of heat, it will turn the blower off.
(g) LIGHTS LED Light Control
This button controls the LED lighting. The first press turns the lights on. A second press dims the
lights. A third press turns the lights off. An 0 –100% light slider in Home Connect app allows
additional control to obtain the perfect level of light.
Page. 9
c
d
0 1
e
2 3 4
f h
g
AUTO LIGHTS CONNECT R H LAMP
i