Ikegami ISD-A33 Manual De Instrucciones página 11

① Lens fixing screws (elevation)
These are screws to fix the camera in the desired elevation position.
Fix these screws after setting the viewing position.
② Vari-focal lens
Can be used with flexible angle of view using varifocal lens.
③ Switches for camera setup
Refer to Section 8 (Operating Procedure)
④ Test monitor output
Connect accessory MONI.OUT output harness.
⑤ Power cable
This is a power cable. Non-polarity AC24V (AC 21.6V ~ 26.4V) or
DC12V has to be connected. Check the power voltage from the external
power supply before applying power to the camera.
* This installation should be made by a qualified service person and
should conform to all local codes.
⑥ Video Output cable (BNC)
This is the output of video signal. Connect this to a monitor or switcher.
⑦ Fixing holes (two key hole slots)
⑧ Dome Cover
E-6