Light Control - Ikegami ISD-A33 Manual De Instrucciones

② COLOR: The color mode can be selected.
③ B/W: The Monochrome (B/W) mode can be selected.
(4) SENS UP
Selection of electronic sensitivity increase mode. Possible to choose
electronic sensitivity increase rate.
① OFF: Electronic sensitivity increase mode is OFF.
② ON: Possible to set the maximum magnification during operation
of electronic sensitivity increase.
The higher the factor, the higher the sensitivity, but motions at
maximum factor look unnatural.

(5) LIGHT CONTROL

The backlight compensation and sensing spot area modes can be
selected. The wide dynamic level and DC type iris lens are adjusted.
Select LIGHT CONTROL on the main
menu screen. Press the SET button,
and the screen at right shows up.
① BACKLIGHT CMP.:
The backlight compensation
modes can be selected.
compensation mode is in effect.
the SET button, and the screen
shown at right appears. Highlight
ADJUST ZONE and press the SET
button, and the BLC compensation
sensing area setting screen comes
up.
Each time the SET button is
pressed, the assigned area color
changes in turn Blue, Green and Red in this order.
Using the UP, DOWN, LEFT or RIGHT button, the field can be
moved wherever you like.
Using the UP, DOWN, LEFT or RIGHT button, the field can be
enlarged.
Using the UP, DOWN, LEFT or RIGHT button, the field can be
reduced.
→BACKLIGHT COMP.
W.DYNAMIC
IRIS LEVEL
LENS IRIS
RET
→ADJUST ZONE↓
RET
E-11
LIGHT CONTROL
OFF
DC
1SPOT ZONE