Camera Installation; Pre-Work Before Installation; Mounting The Camera (Ceiling); Mounting The Camera (Wall) - Ikegami ISD-A33 Manual De Instrucciones

4. Camera Installation

4-1. Pre-work before installation

For camera fixing, two holes are needed.

4-2. Mounting the camera (Ceiling)

Put two fixing screws leaving about 5mm clearance. Those two screws
will be tightened later to secure the dome camera. Put the cable wiring
through the center hole of the camera base ① , and align two key hole slot
to the screws.
And turn the unit clockwise until it stops and tighten two fixing screws. Put
back the dome cover.

4-3. Mounting the camera (Wall)

The way of installation is the almost same as to
a ceiling. Install the main unit so that the switch
becomes upper side as shown in the illustration
right and set the "VIDEO FLIP" in the setup menu
to "VERT".
Holes for camera fixing
②
①
③
E-4
Screws
Camera
Dome cover
Upper
Lower