Imperial/Metric Modes - Calculated Industries Scale Master Classic 6020 Guia Del Usuario

(Cont'd)
[M2x] – Memory Add key (Width)
Adds the displayed value to memory.
This key is used to store a width in order
to calculate an area. When a length and
width have been stored in [M1+] and
[M2x], pressing [Rcl] [M2x] displays the
stored width, the next press of [M2x]
displays the area calculated from the
stored length and width, and the next
press of [M2x] displays the calculated
volume if a height has been stored.
Please see pages 10-12 for storing and
calculating an Area and Volume.
[Reset]
Used to clear the display. When pressed
together with another key, clears the
value of that key.

Imperial/Metric Modes

The Scale Master Classic is set up to use
Imperial (English) dimensional units by
default. The Scale Master Classic can be set up
to use Metric scales by using the following
sequence:
1) Turn unit off via switch.
2) Press and hold [Subtract/Count] key.
3) Turn unit on via switch.
4) Release [Subtract/Count] key.
While in Metric mode, MET will remain lit
in the scale box.
Repeat the procedure above to switch back
to Imperial mode.
4 – Scale Master Classic v3.0
®