Use Of Coinmechanism Bdv - FAS International SPIRALI HDR Manual Del Usuario

Spirali HDR Panzer - Issue 00
9.3

USE OF COINMECHANISM BDV

Installation: To connect the coin mechanism ask the manufacturer for the suitable connection cable (code
300238). After having carried out the connection, switch on the machine, enter the programming and set
command 69 to 4, then switch off the machine for some seconds. By switching it on again the machine and
the coin mechanism will communicate correctly.
Command 30 Purchase obligation before return
Command 31 Maximum credit
Command 32 Maximum value of returned coins
Command 33 Inhibition single coins
Command 34 Inhibition coins small return
Command 35 Coin level message exact amount
Command 36 Equation exact amount
Enabling credit card reader
Command 37
Emptying of change giving tubes
Command 38
Filling up of change giving tubes
Command 39
Command 30 Purchase obligation before return:
By setting this command to 1 the customer is obliged to purchase before receiving back the return. This is to avoid
to use the coin mechanism as a coin-changer. If the purchase fails to happen, the return will be given out.
Command 31 Maximum credit:
The maximum credit accepted by the coin mechanism is set. By overtaking this value the acceptance of
further coins is blocked.
Command 32 Maximum value of returned coins:
This function is active only in multi-sale. If the value of the credit which remains after a sale is higher than the
value set by the command, the allotment of return will be blocked. Therefore it will be necessary to carry out
further purchases until the remaining credit will be lower than the set value. By moving the return lever it will
be possible to obtain the return.
Command 33 Inhibition single coins:
The acceptance of particular coins by the coin mechanism will be blocked through this command. If you want
to block the acceptance of coin 5, proceed as follows:
1. Programming mode, display views ..........................................................................................Command 00
2. Dial 33 and press B, display views ............................................................................................. Coin no. 00
3. Dial 5 and press B, display views ................................................................................................................0
4. Dial 1 and press B.
Command 34 Coin inhibition with exact amount:
This command blockes the acceptance of particular coins in case of small return, i.e. when the display views
the message "Insert only exact amount".
Command 35 Coin level message exact amount:
A value between 0 and 15 representing the number of coins to be added to the minimum level fixed in the
coin return tubes - can be programmed, in order to quit the "exact amount" condition.
Command 36 Equation exact amount:
It represents the combination of empty spaces in the tubes so that the message exact amount can be
activated. Here is a list of possible combinations:
0 = A or (B e C)
3 = A and (B o C)
6 = A or B or C
9 = only B e C
12 = only C
Command 37 Enabling credit card reader:
The functioning of the credit card will be enabled by setting this command to 1.
FAS INTERNATIONAL S.p.A. Via Lago di Vico, 60 SCHIO (VI) – tel. +39 0445 502011 – fax +39 0445 502010 - e-mail: info@fas.it
1 = A and B and C
4 = only A
7 = only A and C
10 = only B
(def. 0)
(def. 0)
(def. 0)
(all enabled)
(all enabled)
(def. 0)
(def. 0)
(def. 0)
2 = only A and B
5 = only A or B
8 = only A or C
11 = only B or C
29
E
N
G
L
I
S
H