Machine Adjustment Procedures; Wheel Adjustment Bona Edge Ux 130; Abrasive Assembly Procedure; Adjusting The Working Surface On The Floor - Bona Edge UX Manual De Funcionamiento Y Mantenimiento

Machine Adjustment Procedures

Wheel adjustment Bona Edge UX 130

1) The distance between the suction elbow and wheel
support should be approx. 16 mm.
Wheel adjustment Bona Edge UX 220
1) The distance between the suction elbow and wheel
support should be approx. 18 mm.
Footprint should be as above to get the best result.
Note! If the whole disc is flat and in full contact with the floor it will
create excessive resistance in the motor, leave circular scratch
marks, and the machine will be hard to handle.

Abrasive assembly procedure

1) Check that the machine is 2) Ensure the Velcro surface of the disc is clean and select an
turn off and unplugged from abrasive disc (178mm diameter) with a suitable grain which
power supply before remove does not have a damaged surface.
the old abrasive disc.
Only use abrasive discs with a diameter of 178 mm.
14
Bona Edge UX
The tilt of working plate is determined by the position of the
wheels on their support. This support slides on a guide and can
be set at the needed position by a locking knob.
Follow the 'Replacing
the cogged belt'
(pag.16) up to point 3.
3) Attach the new abrasive disc
on the Velcro surface of the
metal plate disc.
Machine Adjustment Procedures (Cont.)

Adjusting the working surface on the floor

1.

Wall protection

1. 2.
The wall protection is replaceable in easy
way by unscrewing the two fixing screws
from the two slots, that allow to adjust in
opportune way its distance from the wall.

Routine Maintenance

To keep the machine in good working condition the following
items must be checked and serviced regularly (every 250
working hours or at least once a year).
Bona Edge UX
2.
For moving upward/downward the machine loosen the lower
knob. Turn clockwise/counter-clockwise the screw using the
upper knob. Screw again the lower knob to lock the wheel
position.
All maintenance must be done on neutral machine!
Always disconnected the machine from power supply before
it is cleaned, tools are changed, maintenance is performed or
when worn parts are replaced.
EN
15