Replacing The Velcro Disc; Replacing The Cogged Belt - Bona Edge UX Manual De Funcionamiento Y Mantenimiento

Routine Maintenance (Cont.)

Replacing the Velcro disc

1. 2.
If Velcro disc is worn, scrape Clean the steel disc with
the disc off with a knife. alcohol or similar.

Replacing the cogged belt

1.
Remove the black stopper on the arm machine.
16
Bona Edge UX
3. 4.
Glue a new Velcro disc on the Check that the disc is
steel plate. centered: a disc that is
not centered may cause
unbalances and vibrations.
2.
In order to remove the screw and the tapered washer, you
need first lock the disc pulley. For this purpose to put a
screwdriver inside the arm hole.
Routine Maintenance (Cont.)
Replacing the cogged belt (Cont.)
3.
Remove the metal plate disc (Turn counter-clockwise).
5.
Remove the drive belt guard metal sheet.
7.
Remove the old cogged belt before from the motor pulley
and after from disc pulley.
Bona Edge UX
4.
Remove the sawdust chamber metal sheet.
6.
Remove 4 screws to divide the machine body from the
machine arm.
8.
Fit a new cogged belt on the motor pulley and then on the disc
pulley.
9.
Reassemble all parts.
EN
17