Candy CDIM 3T623PRDF Instrucciones Para El Uso página 17

Programme interruption
Opening the door when a programme is
running is not recommended especially
during the main wash and final hot rinse
phases. However, if the door is opened
while a programme is running (for example,
to add dishes) the machine stops
automatically and the display will flash the
remaining time before the end of the cycle.
Close the door, without pressing any
buttons. The cycle will start from where it
left off.
WARNING!
If you open the door during the
drying cycle, an audible audio signal
advises you that the drying cycle has
not yet finished.
Changing a running programme
Proceed as follows to change or cancel a
running programme:
Open the door.
Hold the "RESET" button down for at
least 5 seconds. "00" will appear on the
display and some audible signals will
sound.
The running programme will be cancelled.
The display will show two lines.
At this point a new programme can be set.
WARNING!
Before starting a new programme,
you should check that there is still
detergent in the dispenser.
If necessary, top up the dispenser.
If there is any break in the power supply
while the dishwasher is operating, a
special memory stores the selected
programme and, when the power is
restored, it continues where it left off.
Programme end
A 5 second alarm will sound (if not muted)
3 times at 30 second intervals to signal that
the programme has ended.
IMPORTANT
If the "SMART DOOR" function is
activated, during the drying phase
the door will open automatically and
you will have to wait until the indication
of the end of cycle before removing
the dishes.
Option buttons
"SMART DOOR" button
(AUTOMATIC OPEN DOOR)
This option activiates a special device that
opens the door a few centimeters during or
at the end of the drying cycle (depending
on the programme). This ensures the natural
and efficient drying of dishes.
The duration of the selected cycle will
automatically
optimiazation of temperatures used during
the rinse phase, this allows a significant
reduction of energy consumption. The
automatic door opening in the last phase of
drying enables the air to circulate,
removing the risk of bad odours.
IMPORTANT
This option is automatically activated
on the "ECO" programme, it is however
possible to disable it.
The function "SMART DOOR" is not
available in the programme "RAPID
24'" and "PRE-WASH".
ATTENTION
With this option selected, you must
not in any way prevent the door from
opening or force it shut, as this will
damage the mechanism.
Ensure that there is free space in
front of the door and before closing
wait for the return opening device.
17
change to allow an