SPECIAL FUNCTIONS
HOLIDAY Function :
With
&
keys, go to
delay in hours ( H ) if below 24h then in days ( d ). Then select a mode
or
.
The
logo is active and the number of hours/days left is displayed until the
MILUX RF returns in
KEYPAD LOCK Function :
Function to prevent any modification of the parameters.
In
,
,
key pressed and press simultaneously on the
(
) or unlock (
RESET Function :
Erase all user programs and sets the factory parameters by default.
Go to
mode, maintain
on the
key.
All segments will lit up during a few seconds showing that the MILUX RF has
been erased and restarted with factory defaults parameters.
Factory parameters are :
Temperatures
RADIO CONFIGURATION
1.
To assign the MILUX RF thermostat with the receiver you must put the
receiver in "RF init" mode, please refer to the receiver leaflet. (In this
mode the thermostat should be near the receiver)
2.
On the MILUX RF, select
Then press the
configuration mode (
The MILUX RF is now sending by radio signal its configuration address 4
times per second,
3.
You can now perform a radio range verification.
Place the MILUX RF in the room where you need to regulate the
temperature and leave it in Radio configuration mode (
Close the doors and come back to the Receiver.
Verify that the green LED blinks at each radio signal received :
- If it blinks regularly 4 times per second, the installation of the MILUX RF
and Receiver is correct.
- If it blinks irregularly, you are at the range limit. Install the MILUX RF
closer to the Receiver.
- If it does not blink at all, you are out of range. Install the MILUX RF
closer to the Receiver.
4.
On the MILUX RF press on the
mode. Now your MILUX RF controls the Receiver.
function. Then select with
mode and continues to follow the program.
,
and
operating modes you can maintain the
) the keypad.
&
keys pressed and press simultaneously
21°C
17°C
key during 5 seconds, you will enter in the Radio
).
or
key to lock
6°C,
Program U1 all comfort.
operating mode.
key to exit the radio configuration
5
&
keys the
or
).
GB