Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
3. Touchscreen
4. MicroSD card slot
2.3
OUTDOOR UNIT (DOORBELL)
1. Microphone
2. Camera
3. Speaker
4. Call button (replaceable, extra button included)
5. Call button 2 (replaceable, extra button included)
6. Lock release time switch (On the back of the unit)
3
Installation
3.1
FIX THE MOUNTING PLATE OF THE
INDOOR UNIT (MONITOR)
To mount the monitor, you will need the following tools:
ü A suitable screwdriver for the included screws.
ü A drill and suitable drill bit for the included screw plugs.
A. Position the provided mounting plate where desired.
B. Mark the screw positions with a pen.
C. Drill the necessary holes.
D. Insert the plugs.
E. Pull the required cables through the mounting plate.
F. Fasten the mounting plate with the screws.
G. Repeat steps a-f for the second monitor.
3.2
FIX THE MOUNTING PLATE OF THE
OUTDOOR UNIT (DOORBELL)
To mount the outdoor unit, you will need the following tools:
ü A suitable screwdriver for the included screws.
ü A drill and suitable drill bit for the included screw plugs.
A. Position the provided mounting plate where desired.
B. Mark the screw positions with a pen.
C. Drill the necessary holes.
D. Insert the plugs.
E. Use a knife or sharp object to puncture the cable gland.
F. Pull the required cables through the cable gland.
G. Fasten the mounting plate with the screws.
3.3
ELECTRICAL INSTALLATION
3.3.1 Connecting the terminal blocks (Indoor
and Outdoor unit)
There are three terminal blocks included. The GREEN (outdoor unit)
and ORANGE (AC power) terminal blocks are always required. In
case you wish to connect an additional monitor a BLUE terminal
block is also available.
To connect the terminal blocks, you will need the following tool:
ü A small flat head screw driver.
A. GREEN terminal block: Loosen the terminal screws.
B. With the terminal facing you, insert the black wire on the left and
the red wire on the right.
Instruction manual
EN
7
Publicidad
Capítulos
Tabla de contenido
