Base Features; Basic Base Station Features - EnGenius EP801 Manual De Usuario

Base Features

Basic Base Station Features

1. Antenna
normal thread connector
a. The antenna port has a
antenna or cable, turn counterclockwise; to install, turn clockwise.
Improper installation may damage the connector.
b. When using an outdoor antenna, locate the antenna (not the base
station itself) as high as possible for a clear transmission path.
2. LED
a. Power: it indicates base station has power.
b. In-Use: it indicates an active telephone line.
c. Broadcast: it indicates "Broadcast" taking place.
d. Mute: it indicates "Mute" is active.
e. Voice Message: it indicates the voice message received.
3. RESET Button
a. Restores base station to factory settings
b. Reset button is intented to prevent accidental system reset.
c. All handsets (including administrator) and additional base(s) need to
be re-registered after a base station reset.
4. Registration Button (REG)
Enters registration mode along with handset, assigns handset ID (11-19).
5. Line Jack
Standard RJ-11C/CA-11A connector to plug in the telephone line
6. Telephone Jack
Another RJ-11C to plug in the optional answering machine
7. Dialing Keys
a. Enter the phone no after pressing the Speakerphone key.
b. Enter the handset ID or Group ID when making the intercom call or
broadcast.
c. Enter the phone no when storing the base speed dial directory.
8. Function Keys
a. TRANSFER (
): during talk, press the key to transfer the call to a
registered handset.
; to remove
~19~
b. MEMORY (
): store phone number into speed dial memory of
base unit. Up to 20 entries. Or retrieve a phone number from the
speed dial memory during the talking.
c.
MUTE ( ): press the key to mute the microphone.
d. HOLD (
): press the key to put the call on hold.
e. FLASH (
): press the key to send a Flash signal to phone line to
retrieve a dial tone after the call ends, or to perform the call waiting
feature provided by local phone companies during a call.
f.
REDIAL/P ( ): press the key to retrieve the last dialed number.
Or store a pause time (1 second) while storing the speed dial
memory.
9. VOLUME keys (
and
a. Increase or decrease the ringer volume during standby mode.
b. Increase or decrease the voice volume during talk mode.
10. SPEAKERPHONE key (
)
a. Press the key to get the dial tone, followed by phone number to
make outgoing call.
b. Press the key again to hang up the call.
c. When enable the speakerphone, the backlight of the key will be
turned on too.
11. INTERCOM/BROADCAST Key (
a. Enter handset ID then press the key to enable the 2-way intercom
feature.
b. Enter handset ID then press and hold the key for over one second to
enable the broadcast feature.
Re: Press the INTERCOM/BROADCAST Key without entering handset
ID first, all registered handset will be enabled.
12. DC In: to plug in the power adaptor
)
)
~20~