EN
6.
OVERVIEW
See page 2.
1
Electronic signal indicator
2
Sliding on/off switch
3
Spindle locking button
4
Handle bar
5
Safety guard
6
Spindle
7
Speed adjustment wheel
8
Handle
7.
COMMISSIONING
Before plugging in, check that the rated
mains voltage and mains frequency, as
stated on the type plate match your power
supply.
Always install an RCD with a maximum trip
current of 30 mA upstream.
7.1 Safety guard
The protective cap can be adjusted if necessary
for the work to be performed. To do so, loosen
the Allen screws of the fixing ring and turn the
protective cap by pulling or pushing on the
handle. Then tighten the Allen screws again.
(See page 2 illustration A)
8.
USE
8.1 Adjusting the speed
Set the recommended speed at the thumb-
wheel (7). (small number = low speed; large
number = high speed)
32
Ι Finimaster Pro
8.2 Switching On and Off
Always guide the machine with both
hands.
Switch on first, then guide the accessory
towards the workpiece.
The machine must not be allowed to draw
in additional dust and shavings. When
switching the machine on and off, keep it
away from dust deposits. After switching off the
machine, only place it down when the motor
has come to a standstill.
Avoid inadvertent starts: always switch the
tool off when the plug is removed from
the mains socket or if there has been a
power cut.
In continuous operation, the machine
continues running if it is forced out of your
hands. Therefore, always hold the machine
with both hands using the handles provided,
stand securely and concentrate.
0
Switching on: Push the sliding switch (2)
forward. For continuous activation, now tilt
downwards until it engages.
Switching off: Press the rear end of the sliding
switch (2) and release the sliding switch.
9.
CLEANING
It is possible that particles deposit inside the
power tool during operation. This impairs the
cooling of the power tool. Conductive build-
Manual
Finimaster Pro
2
I