Pelican 9460 Manual Del Usuario

Battery Safety Information
WARNING: HANDLE AND STORE BATTERIES PROPERLY TO AVOID INJURY OR DAMAGE BATTERIES CAN BE DANGEROUS!
Most battery issues arise from improper handling of batteries, and particularly from the use of damaged or counterfeit batteries. Please review the information below to avoid serious injury and/or damage to
your property.
Rechargeable Batteries
1. Hazardous location safety approvals for explosive environments are only valid for the Pelican battery pack that is supplied with the light.
2. For replacement battery packs only use the approved Pelican battery pack for the model of the light that you are using. The use of other battery packs will invalidate the safety approval.
3. Lights should only be charged in a non-hazardous location.
4. Lights should only be charged using the Pelican charger base that is supplied with the light.
5. Do not charge with alkaline batteries installed in the light. Attempting this can cause internal gas or heat generation resulting in venting, explosion or possibly fire.
6. Deep discharge of the rechargeable battery may cause batteries to vent potentially dangerous gasses and electrolytes.
Always dispose of all batteries properly at an approved battery recycling center.
Información sobre seguridad de las pilas
AVISO: MANIPULAR Y GUARDAR LAS PILAS CON PRECAUCIÓN PARA EVITAR DAÑOS LAS PILAS PUEDEN SER PELIGROSAS.
La mayoría de los problemas relacionados con las pilas surgen al utilizarlas incorrectamente y, sobre todo, al emplear pilas falsas o en mal estado. Consultar la información siguiente para evitar
daños personales o en el producto.
Pilas recargables
1. Los certificados de seguridad para zonas peligrosas en entornos explosivos solo se aplican al paquete de pilas Pelican que se suministra con la linterna.
2. Para cambiar los paquetes de pilas utilizar únicamente las pilas Pelican homologadas para el modelo de linterna correspondiente. El uso de otros paquetes de pilas anulará el certificado de seguridad.
3. No cargar la linterna en zonas peligrosas.
4. Cargar la linterna únicamente en la base de cargador Pelican que se suministra con la linterna.
5. No cargar la linterna con las pilas alcalinas dentro; podría generarse gas o calor en el interior, que podría emanar y provocar una explosión o un incendio.
6. Si las pilas recargables se descargan demasiado rápido pueden originarse fugas de gases peligrosos y electrolitos.
Desechar las pilas en un centro de reciclado homologado.
Informations relatives à la sécurité des piles
AVERTISSEMENT : MANIPULER ET RANGER CORRECTEMENT LES PILES, AFIN D'ÉVITER TOUT RISQUE DE LÉSION CORPORELLE OU DE DOMMAGE MATÉRIEL LES PILES
PEUVENT ÊTRE DANGEREUSES ! La plupart des problèmes liés aux piles sont dus à une manipulation incorrecte, en particulier à l'utilisation de piles endommagées ou contrefaites.
Lire attentivement les informations ci-dessous, afin d'éviter tout risque de lésion corporelle et/ou de dommage matériel de vos produits.
Piles rechargeables
1. Les agréments de sécurité de sites dangereux pour les environnements explosifs sont valables uniquement pour le bloc-piles Pelican fourni avec le système d'éclairage.
2. Pour remplacer le bloc-piles, utiliser uniquement un bloc-piles Pelican homologué pour le modèle du système d'éclairage utilisé. L'utilisation d'autres piles risque d'invalider l'agrément de
sécurité.
3. Le système d'éclairage doit être rechargé uniquement dans un site non dangereux.
4. Le système d'éclairage doit être rechargé uniquement à l'aide de la base-chargeur Pelican fournie avec le système d'éclairage.
5. Ne pas recharger lorsque des piles alcalines sont installées dans le système d'éclairage. Dans le cas contraire, cela pourrait entraîner une production interne de gaz ou de chaleur, provoquant
un dégazage, une explosion ou éventuellement un incendie.
6. Un déchargement important des piles rechargeables peut provoquer un dégazage potentiellement dangereux et une fuite de l'électrolyte.
Toujours mettre au rebut toutes les piles correctement dans un centre de recyclage des piles agréé
PELICAN LIMITED LIFETIME GUARANTEE OF EXCELLENCE
Pelican Products, Inc. guarantees its lights for a lifetime against breakage or defects in workmanship. This guarantee does not cover the lamp or batteries.
Pelican will either repair or replace any defective product, at our sole option. TO THE EXTENT PERMITTED BY LAW, THE REMEDIES HEREBY PROVIDED SHALL BE THE EXCLUSIVE AND SOLE REMEDY OF THE PURCHASER.
TO THE EXTENT PERMITTED BY LAW: (A) THIS WARRANTY IS IN LIEU OF ALL WARRANTIES, EXPRESS OR IMPLIED, INCLUDING, BUT NOT LIMITED TO, THE IMPLIED WARRANTIES OF MERCHANTABILITY AND FITNESS FOR
A PARTICULAR PURPOSE; AND (B) ALL OTHER IMPLIED WARRANTIES AND ANY LIABILITY NOT BASED UPON CONTRACT ARE HEREBY DISCLAIMED AND EXCLUDED.
TO THE EXTENT PERMITTED BY LAW, IN NO EVENT SHALL PELICAN BE LIABLE FOR ANY INDIRECT, PUNITIVE, INCIDENTAL OR CONSEQUENTIAL DAMAGES, OR SPECIAL DAMAGES, REGARDLESS OF WHETHER A CLAIM
FOR SUCH DAMAGES IS BASED ON WARRANTY, CONTRACT, NEGLIGENCE OR OTHERWISE. To the extent permitted by law, in no event shall Pelican's liability to the purchaser for damages hereunder exceed the purchase price of the
product in respect of which damages are claimed.
To make a warranty claim, the purchaser must contact Pelican Products, Inc. at 23215 Early Avenue, Torrance, CA 90505 or csrwarranty@pelican.com, or by calling 1-800-473-5422, extension 5.
Any warranty claims shall be made by the purchaser as soon as practicable. The purchaser must obtain a return authorization number from Pelican Customer Service prior to returning any product, and is responsible for paying for all warranty
freight costs. If Pelican determines that any returned product is not defective, within the terms of this warranty, the purchaser shall pay Pelican all costs of handling, return freight and repairs at Pelican's prevailing rates.
All warranty claims of any nature are barred if the flashlight has been altered, damaged or in any way physically changed, or subjected to abuse, misuse, negligence or accident.
Some states and countries do not allow limitations on how long an implied warranty lasts or the exclusion or limitation of incidental or consequential damages, so the above limitation or exclusion may not apply to you. This warranty gives you spe-
cific legal rights, and you may have other rights which vary from state to state and country to country.
In Australia: The benefits provided to you under this warranty are in addition to your rights and remedies as a consumer under the Competition and Consumer Act 2010 (Cth). Nothing in this warranty limits the rights or obligations of a party
under provisions of the Competition and Consumer Act 2010 (Cth) in relation to the supply to consumers of goods which cannot be limited, modified or excluded. If applicable, our goods come with guarantees that cannot be excluded under the
Australian Consumer Law. You are entitled to a replacement or refund for a major failure and compensation for any other reasonably foreseeable loss or damage. You are also entitled to have the goods repaired or replaced if the goods fail to
be of acceptable quality and the failure does not amount to a major failure. If you are not a consumer under the Competition and Consumer Act 2010 (Cth), then your rights may be limited. To make a warranty claim, the purchaser must contact
Pelican Products Australia, Suite 2.33, West Wing, Platinum Bldg., Erina NSW 2250, Tel: +612 4367 7022. Any warranty claims shall be made by the purchaser as soon as practicable. The purchaser must obtain a return authorization number
from Pelican Customer Service prior to returning any product, and is responsible for paying for all warranty freight costs. If Pelican determines that any returned product is not defective, within the terms of this warranty, the purchaser shall pay
Pelican all costs of handling, return freight and repairs at Pelican's prevailing rates. In the event that Pelican determines that any returned product is defective, within the terms of this warranty, Pelican shall pay the purchaser all reasonable costs
of the purchaser in making claim under this warranty.
Lifetime Guarantee does not cover Roto Molded cases, AALG products or fabric portion of backpacks. Refer to www.pelican.com/warranty for full details.
CON LA GARANTÍA LIMITADA DE EXCELENCIA DE POR VIDA DE PELICAN
Pelican Products, Inc., ofrece una garantía de por vida en sus linternas contra roturas o defectos de fabricación. Esta garantía no cubre la lámpara ni las pilas. Las reclamaciones de garantía de cualquier clase se considerarán nulas en caso
de que el producto haya sufrido alteraciones, daños o modificaciones físicas de cualquier tipo, se haya hecho un uso incorrecto, abusivo o negligente o haya sufrido accidentes. La garantía de por vida no cubre las maletas rotomoldeadas, los
productos del AALG ni la parte de tejido de las mochilas.
GARANTIE D'EXCELLENCE À VIE LIMITÉE DE PELICAN
Pelican Products, Inc. garantit à vie ses torches contre la casse et les défauts de fabrication. Cette garantie ne couvre pas l'ampoule ou les piles. Toute demande de prise en charge sous garantie,
de quelque nature que ce soit, sera refusée si le produit a été transformé, endommagé ou physiquement modifié d'une façon ou d'une autre, ou encore sujet à un traitement abusif, une mauvaise
utilisation, une négligence ou un accident. Pour une version complète et détaillée de la garantie, voir http://www.pelican.com/warranty.
La garantie à vie ne couvre pas les valises rotomoulées, les produits AALG et la partie en tissu des sacs à dos.
© PELICAN PRODUCTS 2013 5-5565 REV D AU/13 9463-311-000 All trademarks and logos displayed herein are registered and unregistered trademarks of Pelican Products, Inc. and others.
RoHS compliant
CATALOG No. 9460
Pelican 9460
The Pelican 9460 Remote Area Lighting System contains two LED light heads, two masts, a 12V
sealed lead acid batteries and a battery charger. Both light heads connected provide a maximum
output of 6000 lumens over a 7 hour period. The masts will extend to a height of 6 feet.
Mast Operation
1. Open the case and remove each mast and LED head.
2. Attach the LED head to the mast by screwing the light head pivot into the mast insert.
3. Close the case lid and stand the case upright.
4. Insert the masts into the pole mounts.
5. Insert the light head plugs into the green sockets on the sides of the product and twist the
green locking collar to secure the plug.
6. Pull open the lever on the mast locking clamp and lift the LED head upwards then snap the
lever back into place.
7. To collapse the mast reverse the procedure.
Light operation
After the light heads have been connected you can now turn them on. Press the power button
once, this will default the burn time to 7 hours regardless of the power level of the battery, the
condition of the battery will be indicated on the display (fig 1).
To increase the burn time press button 1 (Fig 2) This will automatically decrease the light output
performance). The maximum burn time is 40 hours providing combined approx. 1100 lumens
output from each light head.
To decrease the burn time press button 2 (fig 3), (this will automatically increase the light output
performance). When the battery is fully charged the light heads will offer a maximum light output
of 6000 lumens.
Power switch operation sequence
1. Press keypad once to switch on.
2. Press again to switch off.
Flash Mode
1. Press and hold keypad for 3 seconds then the LED head will flash.
2. Press keypad again to switch off.
Low Battery Warning
Before the product turns off, the LED Head will flash for 3 seconds, every ten minutes to let the
user know that the battery voltage is low. The warning period starts 30 minutes before there is
insufficient voltage to power the light.
Battery Charging
Warning – Do not operate the 9460 RALS with the charger connected.
It is advisable to condition batteries every 3 months. Failure to do so will decrease battery life.
Leaving the product unused for long periods of time will decrease battery life.
Withdrawal of the charger from the product prior to a 'READY' indication will result in
inadequate charge.
HAZARD – DO NOT CHARGE THE 9460 WITH THE LID CLOSED
1. Using the charger supplied inside the case, insert the charger plug into the charging socket
situated next to the IC display.
2. Attach the charger to the AC supply until the LED on the charger turns green.
3. Whilst charging the IC display will display the condition of the battery status. (fig 4)
4. If the display shows a battery fail symbol (fig 5) this means the product will not operate
until it is recharged.
Charge Cycle Indication
Red = Fast Charge Mode.
Yellow = 90% Charged.
Green = Fully Charged Maintenance Mode.
Battery Replacement
Contact your dealer for a replacement battery.
To replace, follow the instructions included with the new battery.
Environmental
The sealed lead acid battery should be sent to a recycling center or returned to the
point of purchase.