Bornay WIND 13+ Manual De Instalación página 38

Tail tube / Alternator
The tail is attached to the alternator
at this point. Before bolting the tube
to the alternator, pass the protective
casing through the tail tube. (Once
the tube is bolted, you will not be
able to install the casting).
This joint has two different systems
to secure, one has a bolt going through the tube, and the other one is a
flange system. We first introduce the tail tube into the back side of the
alternator, and match the holes in both pieces. We use now a hexagonal
M8x60 bolt, with two M8 washers, one in each side and an self-locking M-8
nut. Tighten both to 2,5 Kg.
Nacelle
The nacelle protects the alternator from external climatologically agents.
The nacelle is attached with four bolts; two of them are on upper part, one is
on the back with a clamp, and the last one goes in the flange on the lower
frontal section:
On the top of the nacelle there are two holes ready for two M6x15 bolts with
their correspondent wide series M-6 washers and a grover washer, directly
bolted to the alternator
bridge. The assembly order
is: bolt, grover washer and
wide washer.
Next, the clamp bolt must
be tightened at the back
part of the nacelle.
38