Installing Smartburner; Instructions - Pioneering Technologies SMART BURNER Manual De Cuidado Y Uso

INSTALLING SmartBurner

™
SmartBurner is a direct replacement for the removable coil elements found on
all typical North American electric ranges. Installation is very easy.

Instructions

 Your new SmartBurner
coils but not the drip pans. Since drip pans vary from model to model
we've created two different sets of stainless steel rings. The set of Standard
Rings that have been factory installed on the four burner plates are
compatible with most major brands sold in North America. However, most
General Electric and GE-Type
second set of rings packaged separately with your new SmartBurner
If your stove is a GE-Type stove, remove the factory-installed rings and
replace them with the second set of GE-Type Rings. Please be sure to line
up one of the two ring cutouts with the prong end (contact) of the burner
plate. (Note: Standard Rings are larger than GE-Type Rings.) (Picture 1.)
Picture 1
Standard Ring
Remove the existing coil element following the instructions in your
stove/range manual. (This usually involves lifting the coil from the drip pan
and pulling it out of the stovetop plug.) Repeat this for the other coil
elements. (Picture 2.) (Note: Ensure that all stove/element dials are in the
OFF position and that all coil elements are cool enough to touch.)
Picture 2
* GE is registered trademarks of General Electric Company.
™
has been designed to replace your stove's electric
™
*
stoves have drip pans that will require the
GE-Type Ring
™
.
Page 3