Filling The Oil Mister Unit; Use - Parkside PDWE 8 B2 Traducción Del Manual De Instrucciones Original

Filling the oil mister unit

CAUTION!
► Before filling or removing the oil reservoir
make sure that the compressed air mainte-
nance unit has been disconnected from the
compressed air source .
♦ Remove the oil reservoir
locking ring clockwise (see fig . E) . Fill the oil
reservoir with suitable compressor oil until
the max . marking is reached (see Fig . B) .
♦ Then manually rotate the oil reservoir anticlock-
wise to the desired position
(fig . E)
PDWE 8 B2
by turning the
(do not use tools) .

Use

CAUTION!
► Ensure that the connected compressed air line
is clean and oil-free so that the compressed
air maintenance unit can be used properly .
Also make sure that the compressed air
system is pressure-free . In order to minimise
pressure losses, it is preferable to keep the
compressed air lines as short as possible .
♦ Connect the compressed air maintenance unit
to the compressed air source .
♦ First release the locking device by pulling the
air pressure regulator
♦ Set the air pressure regulator
setting by rotating it anticlockwise . The desired
settings are adopted by pressing the air
pressure regulator
♦ Connect the compressed air supply line of the
tool to be connected to the quick coupling
(on the right side – output) of the compressed
air maintenance unit . A triangle "▸" on the
surface of the unit indicates the flow direction
of the compressed air .
♦ Connect the compressed air supply line of
the compressed air source via the connector
nipple (on the left side inlet) of the compressed
air maintenance unit . A triangle "▸" is marked
on the surface in close proximity to the inlet,
which indicates the flow direction of the
compressed air .
(fig . F)
upwards (see Fig . F) .
to the lowest
downwards .
GB │ MT │ 35 ■