Oil Mister Unit; Maintenance And Cleaning - Parkside PDWE 8 B2 Traducción Del Manual De Instrucciones Original

Oil mister unit

The oil mister unit is connected to the filter unit
Its function is to lubricate the filtered compressed air
which is being transported in the direction of the
compressed air tool .
The fill level of the oil reservoir
oil mister unit) can be inspected through the trans-
parent viewing window . Use only oil that is suitable
for this compressed air maintenance unit (see
above) .
♦ Turn the oil outlet screw
sight glass) clockwise ("–") to reduce the
amount of oil required . Turn it anticlockwise
("+") to increase the amount of oil .
♦ The integrated sight glass makes continuous
monitoring of the filtered compressed air
possible .
♦ To top up the oil, unscrew the screw of the oil
refill inlet with a suitable Allen key . Fill the
container with the help of a suitable funnel and
then replace the screw using the Allen key .
Fault Causes
Oil outlet screw
turned too far
in direction ("–") .
Insufficient
The compressed
lubrication .
air oil quantity is
too low, i .e .
below the
minimum fill
quantity .
The oper-
ating pres- The pressure
sure of the regulator
compressed closed too
air is too tightly .
weak .
PDWE 8 B2
(integrated in the
(mounted on the
The solution
Increase the oil
quantity
Pour more oil
into the oil
reservoir .
Pay attention to
the maximum
filling quantity .
is Increase the
pressure .

Maintenance and cleaning

.
WARNING! RISK OF INJURY!
Disconnect the appliance from
the compressed air supply.
NOTE
► The compressed air maintenance unit must be
serviced and overhauled at regular intervals
to ensure proper functioning and compliance
with safety requirements . Improper and incor-
rect operation can lead to failures and
damage to the appliance .
■ Never use harsh and/or abrasive cleaning
agents or solvents . These could damage the
plastic parts of the compressed air mainte-
nance unit .
■ Never allow water to get inside the oiler .
■ Make sure that the housing and the inside of
the compressed air maintenance unit remain
free of dust and dirt . To ensure this is the case,
wipe the compressed air maintenance unit
regularly with a clean cloth .
■ Clean the compressed air maintenance unit and
the connections at regular intervals with a damp
cloth .
■ Empty the tank of the compressed air mainte-
nance unit at regular intervals . To do this, press
the drain valve
upwards . Please note that the compressed air
maintenance unit must be pressure-free for
safety reasons .
Disconnect the compressed air maintenance
unit from the compressed air source .
The drain valve
nected from the compressed air .
(see fig . G) on the underside
opens as soon as it is discon-
GB │ MT │ 37 ■