Important - WINK leakSMART Manual De Instalación Y Operación

leakSMART
™
Professional Installation Steps
4.
Open both hot and cold handles on the faucet nearest the
valve to relieve water pressure
5.
Install the leakSMART
meter, to prevent damage to water meter. The valve will also need to
reach an AC power source. It is recommended that the valve is kept
Water Flow
operating on AC power (cord provided), with batteries used as a
back-up power source.
IMPORTANT: The valve must be installed after the water main manual
shut-off and water meter. It is recommended that the valve be installed
at least 8 inches away from water shut-off to avoid damage.
Additional fittings may be required.
•
•
6.
Once installed, close the faucet, turn on the main water valve
and check for leaks
7 .
Reattach the valve cover by sliding it over the motor housing,
with the front facing you
Valve at least 8 inches away from the water
™
Do not solder fittings near the water meter
Position the valve so that the arrow on the side points
away from the water meter
10