Homeowner System Setup - WINK leakSMART Manual De Instalación Y Operación

leakSMART

Homeowner System Setup

It's never been easier to stay in control of your home's water supply.
Setting up your leakSMART
your smart home system and getting your leakSMART
3
™
system is as simple as launching an app, pairing with
™
1.
Pair your valve with your smart home system
• Place your leakSMART
location, so you can verify that it is within range of your
smart home system hub. Install 4 AA alkaline batteries
(not provided), and a flashing blue light will indicate that
it's ready to pair. It is recommended that you keep your
valve operating on AC power (cord provided) and only use
batteries as a back-up power source.
If the light stops flashing, press the center button
}
to reset Pairing Mode
• Use your smart device to add the leakSMART
smart home system app.
When pairing is successful, your hub will beep
}
and the blue light on the leakSMART
blink 3 times
CAUTION: Read installation instructions BEFORE installing batteries in your leakSMART
Valve or Sensors.
Valve installed.
™
Valve near your installation
™
Valve will
™
Valve to your
™
™