Troubleshooting; Maintenance; Storage, Transport, Disposal And Recycling; Limited Warranty - Permobil ROHO AGILITY CARBON Manual Del Usuario

Troubleshooting

For additional assistance, contact the equipment provider, distributor, or Customer Support.
The hardware is loose on the
wheelchair back canes.
The hardware won't fit onto the
wheelchair back canes.
The hardware will not tighten or
stay secure.
The back support appears to
be unevenly installed.
The air insert is not holding air.
The air insert does not feel
comfortable.
The air insert slides out of
position.

Maintenance

Warning: DO NOT continue to use the product if any part is broken, cannot be tightened, or is not functioning properly. Periodically, the product should be
thoroughly inspected by a qualified technician.
Check daily to confirm the tightness of screws and hardware. Re-tighten loose screws, following the instructions in this manual. Check components daily for wear
or damage and replace if necessary.
Storage, Transport, Disposal, and Recycling
Storage or Transport: Clean and disinfect the product. Open the inflation valve. Place in a container that protects the product from moisture, contaminants and
damage. After storing or transporting, inspect the product to ensure it was not damaged (see "Troubleshooting"), and follow instructions to prepare the product
for use.
Disposal: The components of the products in this manual are associated with no known environmental hazards when properly used and when disposed of
in accordance with all local/regional regulations. At the end of its useful life, treat as healthcare waste and dispose of according to local healthcare-waste
guidelines. Incineration must be performed by a qualified, licensed waste management facility.
Recycling: Contact a local recycling agency to determine recycling options for the product.

Limited Warranty

Limited Warranty Term, from the date the product was originally purchased: Back Shell and Hardware: 60 months; Cover, Foam Pad, Foam Insert, Lumbar Support
Pad and Air Insert: 18 months. See also the Limited Warranty supplement provided with the product, or contact Customer Support.
ROHO AGILITY CARBON Contour Back Support Operation Manual
The wheelchair canes are too small. Check the outer cane clamp size. If the back canes on the wheelchair are ¾ in. (2 cm)
in diameter, you must use the ¾ in. (2 cm) Outer Cane Clamps. See "Hardware Selection".
The wheelchair canes are too large. Check the outer cane clamp size. If the back canes on the wheelchair are 1 in. (2.5 cm)
in diameter, you must use the 1 in. (2.5 cm) Outer Cane Clamps. See "Hardware Selection".
» Make sure that the hardware is correctly sized. See "Hardware Selection".
» Mare sure the hardware is correctly assembled and oriented to the back shell. The markers on the back shell
should align with the marker on the inner cane clamp. See "Hardware Attachment".
» Use a tape measure or ruler to make sure the hardware is at the same height on both wheelchair canes.
» Make sure the same discs are used on both sides (for example, AB and BA; not AA and BA). See "Hardware
Attachment".
Inflate the air insert. Inspect the inflation valve and hose for damage. Confirm that the inflation valve is completely
closed. Look for holes in the air insert. If very small holes or no holes are visible, follow the instructions in the Repair
Kit provided with the product.
» Add or remove air to adjust to the comfort level. See "Air Insert Adjustment".
» Make sure the air cells are facing the individual and the cover is properly positioned. See "Cover Removal and
Installation" and "Foam Pad and Air Insert Removal and Installation".
Make sure the air insert is properly positioned and the fabric back of the air insert is secured to the fastener strip in
the cutout area of the foam pad. The perimeter of the air insert should be tucked in between the foam layers around
the edge of the cutout area. See "Foam Pad and Air Insert Removal and Installation".
15