Powering The Unit; Getting Started - Waterpik Water Flosser WP-250 Manual Del Usaurio

Powering the Unit

Plug the cord into an electrical outlet. If the outlet is
controlled by a wall switch, be sure it is turned on.
Preparing the Reservoir
Remove the reservoir, and fill with lukewarm water.
Replace the reservoir over the base and press
down firmly.
Fill
Replace
Inserting and Removing Tips
Insert tip into the center of
the Water Flosser handle,
pressing down firmly until
the tip clicks into place. The
colored ring will be flush with
the top of the handle if the tip
is correctly locked into place.
To remove tip from the handle
push the tip eject button on
the handle.
Prime Unit (First
Time Use Only)
O
I
Set pressure control dial
2
1
3
on base to high (pressure
setting No.3), point the handle and tip into sink. Turn
power on until water flows from the tip. Turn unit OFF.

GETTING STARTED

Tip
release
button
O
I
ON
2
High
1
3
7
NO
gap