Scan Mode - Leica RANGEMASTER CRF 1600-R Manual Del Usaurio

SCAN MODE

61
72
The Leica Rangemaster CRF 1600-R can also be used
for continuous measurements (scan mode):
Hold down the main button
After around 2.5 seconds, the device switches to scan
mode and then carries out continuous measurements.
This can be seen by a change in the display. Around
every 1 second, a new measured value is shown.
65
Scan mode is particularly useful for measuring the
range to small or moving targets.
Notes:
• In scan mode, the
last measurement.
• Because of the continuous measurements, power
consumption is greater in scan mode than for single
measurements.
2
at the 2nd press.
value is displayed after the
EHr
EN
25