Important; Setting The Zeroing Range - Leica RANGEMASTER CRF 1600 Manual Del Usaurio

Example:
If is displayed and you use a riflescope
on which an adjustment by one graduation (click)
results in a correction of 1cm/100m, you can
make the required correction easily by turning by 7
graduations upwards. The same applies for ballistic
reticles.
• Holdover corrections for ranges above 500m are
not shown due to the overall uncertainty factors.

Important:

The holdover display is explicitly intended as a guide.
Regardless of whether you use this information, the
final assessment of the hunting situation and firing of
an expert shot is, as always, your responsibility alone.

SETTING THE ZEROING RANGE

1. Briefly press the main button (2 / <3 s).
• The target mark appears.
2. Press and hold the secondary button (1 / ≥3 s).
• appears below the target mark. The display
flashes to indicate that a setting can be made.
This also applies to all subsequent displays up to
saving the setting in step 5.
3. Briefly press the main button.
• The display changes to
4. Briefly pressing the secondary button several
times selects the required zeroing range.
– [m],
– [m] or
– [m], or
– [y] or
– [y]
5. Save your setting by briefly pressing the main
button.
• The saved setting is displayed for 2 s as confir-
mation and then disappears.
29
.