Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
11. Automated Learning Process./Activating Code.
CAUTION: The wall and/or handheld remote control can be programmed to
multiple receivers or fans. If this is not desired, turn wall switch off to any other
programmable receiver or fan.
Restore electrical power and then, if using wall control, set slider switch on
wall control to the ON position. Within 60 seconds of turning on the wall
control, press and hold the fan OFF button on the wall control for 5 seconds
(or until light blinks twice or fan blades begin to turn).
Turn power off again for at least 5 seconds and then turn power back on.
Within 60 seconds of restoring the power, press and hold the OFF button on
the front of the handheld remote control for 5 seconds (or until light blinks
twice or fan blades begin to turn).
Test the light and fan functions to confirm the learning process is complete--
see Section 13 below.
12. Remote Control Operation.
ON/OFF slider switch - turns wall control ON or OFF
HIGH button - turns fan to HIGH speed
MED button - turns fan to MEDIUM speed
LOW button - turns fan to LOW speed
OFF button - turns fan OFF
L1 button - (not applicable for this fan)
L2 button - turns light kit ON/OFF when pressed once;
dims light kit when pressed and held down
REV button - used to REVERSE blade direction
(fan must be set on low before reversing blade
direction)
13. Testing Your Fan.
It is recommended that you test fan before finalizing
installation. Restore power from circuit box and light switch (if
applicable). Test wall control (optional installation) by locating
ON/OFF slider switch on wall control, then set to the ON
position. Test the light ON/OFF and dimmer function with
L2 button and then test fan speeds. Next, locate handheld
remote control. Test the light ON/OFF function by pressing the
L2 button; test the dimmer function by pressing the L2 button
and holding it down for 1 second. Test fan speeds with the
different fan speed buttons. If the wall and/or handheld
remote control operates all of the functions of the fan and
light, batteries have been installed correctly. If the wall and/or
handheld remote control do (does) not operate all of the
fan/light functions, refer to "Troubleshooting" section to solve
any issues before contacting Customer Service.
Fan must be on LOW before setting the fan to reverse
direction. Use "reverse" button to recirculate air depending on
the season.
NOTE: If the wall control/handheld remote control interferes
with other appliances, turn off power and go back to the
instructions in Section 11 above.
(switch not functional on handheld remote)
wall control
page 8
-
1 1
-
2 2
handheld
remote control
-
1 1
-
2 2
Publicidad
Capítulos
Tabla de contenido
