Canopy Assembly; Automated Learning Process./ Activating Code - Craftmade Ellington FARII13ABZ3RW Guia De Instalacion

7. Canopy Assembly.

Locate 2 screws on underside of hanging bracket
and remove screw closest to the open end of the
hanging bracket. Partially loosen the other screw.
Lift canopy to hanging bracket. Place rounded
part of slotted hole in canopy over loosened
screw in hanging bracket and push up. Twist
canopy to lock. Re-insert screw that was removed
and then tighten both screws securely. Slide
canopy cover up to canopy, aligning rounded part
of slotted holes in canopy cover with screwheads
in bottom of canopy. Turn canopy cover to the
right (clockwise) until it stops.
*Remember that antenna for remote control
receiver must rest outside of hanging bracket.
8. Automated Learning Process./
Activating Code.
CAUTION: The remote control transmitter can be
programmed to multiple receivers or fans. If this is
not desired, turn wall switch off to any other
programmable receiver or fan.
Remove battery cover from back side of remote
control transmitter.
Use a ballpoint pen or a small screwdriver to set
the code switches 1 through 4 for the transmitter.
Use the same number sequence used when wiring
the wall control in Section 6.
Install 9-volt battery (sold separately) in
transmitter. Re-attach the battery cover after
installing battery.
IMPORTANT: To prevent damage to transmitter,
remove the battery if not used for long periods.
Restore electrical power and then set slider switch
on wall control to the ON position. Within 30
seconds of turning wall control on, press and hold
the "OFF" button on the transmitter for 5 seconds
or until you see the fan start to rotate to the left
very briefly and then switch to the right. Proceed
to Section 11 to verify that the automated learning
process is complete.
screw
canopy
TRANSMITTER
page 6
antenna
hanging bracket
screw
canopy cover
code
switches
(back)
battery
battery
TRANSMITTER
cover
pen
(front)