Automated Learning Process./ Activating Code; Wall Control Operation - Craftmade VS60OB5 Guia De Instalacion

10. Automated Learning Process./
Activating Code.
CAUTION: The remote control transmitter can be
programmed to multiple receivers or fans. If this is not desired,
turn wall switch off to any other programmable receiver or
fan.
This remote control transmitter is equipped with 16 code
combinations to prevent possible interference from or to
other remote units such as garage door openers, car
alarms or security systems. If you find that your fan and
light go on and off without using your remote control,
simply change the combination code in your remote
control transmitter (and wall control). To set the code,
perform these steps:
Remove battery cover from back side of transmitter.
Use a ballpoint pen or a small screwdriver to set the code
switches 1 through 4 for the transmitter. Use the same
number sequence used when wiring the wall control in
Section 6 (page 6).
Note: The dimmer switch (labeled D and X) has been
pre-set to the "ON" position (D). If you do not wish to have
dimming capability, please move the switch to the "OFF"
position (X).
Install 12-volt battery (included) in transmitter and then
re-attach the battery cover.
IMPORTANT: Store the transmitter away from excess heat
or humidity. To prevent damage to transmitter, remove the
battery if not used for long periods.
Restore electrical power and then set slider switch on wall
control to the ON position. Within 30 seconds of turning on
the wall control, press and hold the "OFF" button (
located on the front of the transmitter, for 5 seconds or
until lower light on fan blinks twice. Test the fan and light
functions to confirm the learning process is complete--see
Section 13.

11. Wall Control Operation.

ON/OFF slider switch - turns wall control ON or OFF
HIGH button - turns fan to HIGH speed
MED button - turns fan to MEDIUM speed
LOW button - turns fan to LOW speed
OFF button - turns fan OFF
L1 button - turns lower light ON/OFF when pressed once; dims
lower light when pressed and held down
L2 buton - turns upper light ON/OFF when pressed once; dims
upper light when pressed and held down
REV button - used to REVERSE blade direction (fan must be set on
low before reversing blade direction)
dimmer
switch
),
page 9
transmitter
code
(back)
switches
12V battery
battery
cover
transmitter
(front)
L1 L1 L2 L2
- 1 1
- 2 2