Fiap SpaltSkim Active 12000 Manual Del Usuario página 5

FIAP SpaltSkim Active
1x skimmer-weir out of stainless steel, including floating body
2x EPDM gasket-rings suitable for stainless steel flange
1x stainless steel flange
10x flat head screw out of stainless steel, with cross slot M5 x 14 mm
Description
For the mechanical water treatment of garden-ponds, close to nature swimming-ponds and swimming-
pools is the FIAP SpaltSkim a professional extraction system for water surfaces. This is an absolute
innovation in the development of surface-suction devices. The long-time approved FIAP SpaltSieve
Active (300 micron) holds even smallest dirt particles and algae back.
•
Recommended pump-capacity 4.500 l/h -12.000 l/h for the FIAP SpaltSkim Active 12.000
Recommended pump-capacity 4.500 l/h -20.000 l/h for the FIAP SpaltSkim Active 20.000
• Outstanding suction-capacity
•
Ideal for gravity-filtersystem and pumped filtersystem
• Easy installation and maintenance through flanging of foil
•
Alternative installation into the masonry (wall thickness up to 26 mm)
• With FIAP Aqua Active Profi or FIAP Aqua Active Eco pumps compatible
•
Pipe-connection DN150 and pump-connection 1 ½" inside thread
• Material stainless steel
Assembly
For an optimal degree of efficiency the device for the suction
of the water-surface (FIAP SpaltSkim Active) should be mounted against the main wind direction. The
Technische Änderungen vorbehalten. Für Druckfehler übernehmen wir keine Haftung. WEEE-Reg. Nr.: DE78152045
FIAP GmbH, Jakob Oswald Str. 16, 92289 Ursensollen
Tel: 09628 9213 0; Fax: 09628 9213 30;
9
www.fiap.com
FIAP SpaltSkim Active
main wind direction is mostly the east bank. So the dirt-particles can float perfectly in the direction of
the suction-opening. To support this process you can create additional water-streaming. During
installation make sure that no plants or rocks are placed in front of the suction-opening. They can
reduce the efficiency of the device for the suction of the water-surface (FIAP SpaltSkim Active).
Installation according to the sequence of the pictures
1. Use a skimmer-flange for marking.
2. When made out of metal sheet, plastic material or fiber glass drill with a drill machine a hole in
each of the four corners, inside the marking of the skimmer-flange. If it is a pond-foil then use a
sharp knife for this.
3. With a jigsaw you cut the metal-sheet, plastic material, fiber glass and so on out.
4. If necessary use a file to true and strip the cut.
1 2
Important:
The water-level of the pond or pool cannot be lower than 60 mm under the top edge of the skimmer-
flange (equals a maximum water level of 15 mm – 20 mm under the closed skimmer-weir).
Technische Änderungen vorbehalten. Für Druckfehler übernehmen wir keine Haftung. WEEE-Reg. Nr.: DE78152045
FIAP GmbH, Jakob Oswald Str. 16, 92289 Ursensollen
Tel: 09628 9213 0; Fax: 09628 9213 30;
soft materials hard materials
3 3
www.fiap.com
10