gala gar GAR CUT 550 Manual Técnico De Instrucciones página 22

GAR CUT (V. PROFESSIONAL). Instructions Manual. 22
ELECTROMAGNETIC COMPATIBILITY (CEM).
The user is responsible for the installation and use of the welding material according to the instructions in this
manual and the following recommendations.
Before installing the welding material, the presence of the following in the surrounding area must be kept in
mind:
• Wiring for power, control, signalling, and telephones.
• Radio and television receivers and transmitters.
• Computers and other control equipment.
• Critical security equipment.
• People with pace makers or hearing aids.
• Measurement and calibration equipment.
In order to reduce EMC problems, keep in mind the time of day when welding or other activities will be carried
out. Move possible interference victims away from the welding installation.
ALWAYS CONNECT THE MACHINE TO POWER USING AN EFFICIENT EARTH TAP.
IF PROTECTIVE DEVICES OR SUPPLEMENTARY ELECTRICAL SYSTEM FILTERS ARE NEEDED, CONSULT OUR
TECHNICAL SERVICE.
PERFORM THE MAINTENANCE OPERATIONS DESCRIBED IN THIS MANUAL.
USE THE SHORTEST WELDING WIRES POSSIBLE AND KEEP THEM PLACED NEXT TO EACH OTHER NEAR THE
FLOOR.
IF THE WELDING PIECE IS GROUNDED, KEEP IN MIND OPERATOR SAFETY AND NATIONAL
REGULATIONS.