Connecting A Peripheral Usb Device - Sony UPA-PC500 Guia De Instalacion

• We recommend that you wire all device cables
through the holes at the rear of the unit and bundle
them properly with cable ties.
3
After all other connections are complete, connect
the power cord to an AC power outlet.
4
Turn on the AC power supply switch.
5
Close the cabinet.
For details, see "To close the cabinet" on page 7.
Connecting a Peripheral
USB Device
Follow the procedure below to connect a peripheral USB
device to one of the designated USB ports inside the
unit. For details on connecting a specific device, refer to
the manual that came with the device.
Supported USB devices
The following peripheral USB devices can be connected
to the internal USB ports on the UPA-PC500:
• UP-DR150 (Sony Digital Photo Printer)
• UP-D75 (Sony Digital Photo Printer)
• Flatbed scanner
Notes
• To avoid causing a fire or damaging the unit, never
attempt to connect an unsupported device. For more
details about the types of devices supported by the
unit, consult your dealer.
• Up to three UP-DR150 printers can be connected to
the UPA-PC500.
• Up to one UP-D75 printer can be connected to the
UPA-PC500.
To connect a USB device
1
Open the cabinet.
For details, see "To open the cabinet" on page 6.
2
Connect one end of the USB cable to one of the four
designated USB ports inside the unit, and wire it
through the right-hand hole at the rear of the
cabinet.
Notes
• The four designated USB ports for connecting
peripheral USB devices are shown by 1 under
"Internal Connectors" on page 7.
• When wiring and bundling cables, leave some
slack inside the cabinet to prevent a sudden pull
on the cable from disconnecting the cable or
damaging the connector.
• We recommend that you wire all device cables
through the holes at the rear of the unit and bundle
them properly with cable ties.
3
Connect the other end of the USB cable to a USB
port on the device.
4
Turn on the peripheral USB device.
5
Close the cabinet.
For details, see "To close the cabinet" on page 7.
Notes
• Connect peripheral USB devices directly to the USB
ports on the unit. Operation through a USB hub is not
guaranteed.
• If a message prompting you to install drivers appears
when you connect supported peripheral devices to the
unit, contact your dealer.
• When the UP-DR150/UP-D75 is connected to the
UPA-PC500 and powered on, the following dialog
appears:
"A change of device connection has been recognized.
Please wait for a while.", and "The connection has
been made in the system."
Do not operate the system while the dialog is
displayed.
• The UP-DR150/UP-D75 cannot be recognized by the
system while background printing is being executed.
9
Connections