Specific Safety Instructions For Cut-Off Saws - Femi CS 20-140 Manual De Instruccione

SPECIFIC SAFETY INSTRUCTIONS FOR CUT-OFF SAWS

1. ALWAYS disconnect the cut-off saw from the socket before any repair, maintenance work,
cleaning, replacement of the saw blade or any kind of intervention.
2. DO NOT START the cut-off saw until it is completely assembled and installed according to
the instructions of this manual, the protection devices are assembled and working, and the
various lock handles are firmly tightened. Be sure that the lock screw of the disc is firmly
tightened.
3. PLACE the cut-off saw on a plane and horizontal surface to avoid dangerous oscillations or
movements.
4. KEEP your hands away from the disc's track and area.
5. CORRECTLY FIX the workpieces. The workpiece must be straight and properly blocked to
avoid any movement and to prevent the workpiece from jamming at the end of the cutting.
6. NEVER CUT freehand.
7. BE SURE that the disc is completely still before removing or fixing the workpiece or before
changing its angle.
8. ALWAYS CHECK that the disc is not cracked or damaged before using this tool. Immediately
change the disc if it is cracked or damaged.
9. ONLY USE reinforced and recommended abrasive discs.
10. CHECK that the speed of the disc you are assembling is bigger than the one of the machine,
only use discs that can bear a speed of 3900 RPM.
11. CORRECTLY CLEAN the flanges and the supporting surfaces of the disc before assembly.
12. PROPERLY TIGHTEN the lock screw to prevent the disc from slipping, while being careful not
to damage the disc by deforming the contact surfaces with the flanges.
13. ONLY USE disc flanges intended for this tool.
14. MAKE the cut-off saw work without cutting after changing the disc to check that it works
correctly.
15. ALWAYS MAKE the tool work for about a minute before cutting. If the disc has a crack or a
fault which is not visible, it can break within a minute.
16. BE SURE that the abrasive disc is not in contact with the workpiece before starting the tool.
17. LET the motor run at its normal speed before using it.
18. ALWAYS USE the protective cap and be sure that it is perfectly efficient.
19. ALWAYS USE ear protection devices, protective goggle, the dust mask and protective shoes.
20. SLOWLY LOWER the disc until it come into contact with the workpiece, then lower it more
quickly during cutting. Always keep the disc in contact with the workpiece, in order to prevent
it from becoming oval. If the disc is oval, besides causing mediocre cuts, can entail dangerous
breakings.
21. LEAN on supports the ends of big and heavy workpieces, in order to prevent the workpiece
from falling and the risk of injuries.
22. USE this tool only for ferrous materials. DO NOT CUT wood, aluminium or magnesium.
23. PLACE the tool while taking into account the throw of glowing sparks.
24. REGULARLY CHECK if the power supply cable is damaged, and if it is the case get it repaired
by an authorised after-sales centre. Regularly check the extension leads and change them if
they are damaged.
25. IMMEDIATELY STOP the saw and disconnect it from the power supply if you realize that
any part is damaged or faulty. Get the faulty part changed by an after-sales centre. Only use
spareparts and accessories recommended by us.
EN
23