Playcore Swing-N-Slide PB 8233 Instrucciones De Montaje página 35

Pirate's Ladder
Pirate's Ladder
Pirates Ladder.
1. Bolt Pirates Ladder to top 4'' x 4'' support at 3 locations
as shown using (3) 3/8'' loc nuts and (3) 3/8'' flat
washers (Fig. 28).
Note: Refer to (Fig. 21) for accessory arm placement.
3. Using two rope staples to secure the bottom of each
Pirate's Ladder rope. Tap two staples in place
approximately 1'' apart. Wrap the rope under the
4'' x 4''. Then thread the rope through both staples.
Double the rope back on itself and through the first
staple. Pull the rope tight and secure in place by
pounding staples in place. See (Fig. 28b).
4. Repeat for remaining Pirate's Ladder rope ends.
Fig. 28a
2. Attach bolt covers over loc nuts at all three locations
using (2) 1-1/4'' deck screws each, as shown in
(Fig. 28a).
Fig. 28b
35
Assembly Plan
Fig. 28
1''
1''