Configuration - Velleman DVR8H2 Guía Rápida

Pin
Pin 2
Pin 15
9.2

Configuration

Before configuring push video, make sure that:
The DVR system is set up as described in Hardware Setup and Preliminary Settings.
•
The DVR is connected to internet.
•
You have installed the EagleEyes app on your iPhone, iPad, or Android mobile devices.
•
For details, please refer to Mobile Surveillance via EagleEyes.
To configure push video:
1. Right-click to show the main menu and select ADVANCED CONFIG > NOTIFY.
2. Set GUARD to ON.
3. Configure your alarm sensor type (normal open or normal closed).
Careful! You have to select the opposite type for push video to work correctly.
If your alarm sensor is N.C. (normal closed, alarm goes off when the contact opens), then select
•
ALARM N.O.
• If your alarm sensor is N.O. (normal open, alarm goes off when the contact closes), then select
ALARM N.C.
CAMERA
DETECTION
ALERT
NETWORK
DISPLAY
RECORD
DEVICES
DCCS
IVS
NOTIFY
EXIT
4. Open EagleEyes and add this DVR to the EagleEyes address book.
Note: For more information on EagleEyes operation, please visit www.eagleeyescctv.com.
5. Enable push video.
V. 03 – 23/10/2014
DVR8H2
Corresponding video channel
CH1
CH2
ADVANCED CONFIG
PUSH VIDEO PUSH MESSAGE
GUARD
CH01 ALARM OFF / INTERNAL ALARM
CH02 ALARM OFF
MESSAGE MAIL
10
VIDEO MAIL
ON
 CH1
 CH2
©Velleman nv